Measuring for centre
graphics
Using a tape measure find the length of your
hood/bonnet in the centre. eg. measure from the windshield
to the bumper. This distance will allow you to estimate how
far you want the banner/roll-call graphics to extend and how
many logos you require. Note that width is also an issue.
Roughly take note as to how wide you want you graphics to
be by using the tape measure.
Now use the sizing graph (on right) to estimate
what size and the number of logos you require.
note: as banner / roll-call
graphics are made from using different logos, the sizing dimmensions
we suggest are only approximates. Please contact Bladerunner
Graphics before ordering if you require specific dimmension
and/or additional logos.
| This graph shows
the approximate dimmensions based on using 9 logos.
| When using less
than 9 logos allow the following:
200mm allow 43mm per logo
250mm allow 54mm per logo
300mm allow 65mm per logo
350mm allow 75mm per logo
400mm allow 86mm per logo
450mm allow 97mm per logo
500mm allow 108mm per logo
550mm allow 119mm per logo
590mm allow 128mm per logo |
